[Main] [Docs] [Installs] [Search] [Team] [Guestbook] [Links]

Cyberblast< >Cyber Cop

Cybercon III (U.S.Gold)

download the install packageCybercon3.lha
created at2007-04-05
size of install package75055 Bytes
Author/Contact
(use it to report problems with that install)
Graham & Wepl
Mantis BugTracker519
Hall Of Light3159
Lemon Amiga292


	THIS PACKAGE COMES WITH ABSOLUTELY NO WARRANTY OF ANY KIND, EITHER
	EXPRESS OR IMPLIED, STATUTORY OR OTHERWISE.
	THE ENTIRE RISK AS TO USE, RESULTS AND PERFORMANCE OF THE PACKAGE IS
	ASSUMED BY YOU AND IF THE PACKAGE SHOULD PROVE TO BE DEFECTIVE, YOU
	ASSUME THE ENTIRE COST OF ALL NECESSARY SERVICING, REPAIR OR OTHER
	REMEDIATION.
	UNDER NO CIRCUMSTANCES, CAN THE AUTHOR BE HELD RESPONSIBLE FOR ANY
	DAMAGE CAUSED IN ANY USUAL, SPECIAL, OR ACCIDENTAL WAY, ALSO IF THE
	OWNER OR A THIRD PARTY HAS BEEN POINTED AT SUCH POSSIBILITIES OF
	DAMAGE.


	That install applies to "Cybercon 3" © 1991 US Gold.


	That install requires WHDLoad and DIC to be in the path. Both
	can be found in the WHDLoad package.
	To install from a different drive than DF0: select Expert as
	installation mode.


	You need 0.5 MB ChipMem and 0.5 MB OtherMem.
	You can quit the game by pressing DEL (key can be changed with
	Tooltype "QuitKey=")


	Press F9 to open locked doors.
	If you cannot leave the save room after saving just Esc and Restore,
	then it should work. Also using any three symbols for the sonic key
	should work to open the door.


	Currently three versions are supported, you can identify them in
	the startmenu, one shows "CYBERCON III (4/6/91)" and the other
	shows "CYBERCON III (8/6/91)".
	The third version also shows "CYBERCON III (8/6/91)". It has only
	very small differences to the other 8/6.

	Save games cannot be exchanged between the different game versions!

	Using Custom1=1 some fastmem support will be enabled. With fastmem
	support you can not restore the save with a different memory
	configuration. The memory configuration may change if you start
	other programs before WHDLoad.


	if you have problems with this installation please report them via
	the Bug-Report-Form which can be accessed on 
	http://www.whdload.de/

	for full WHDLoad package and other installs refer to:
		http://www.whdload.de/
	or	aminet:dev/misc/whdload#?
	and	aminet:game/patch/


	Thanks to Wolfgang Unger for the original, to Carlo Pirri for
	for providing a second version and to Phil for a third one.

	version 1.4 (10.01.1999) by Graham

	version 1.5 (16.01.2007) by Wepl:
	- increased slave version to work with WHDLoad v16+ (thanks to
	  Angus Manvaring for report)
	- snoop faults removed
	- new install script, docs and icons added

	version 1.6 (03.03.2007) by Wepl:
	- SMC fixed to work with caches enabled
	- protection fix corrected, now only doors for the manual
	  protection will open automatically
	- stack relocated to fastmem
	- decruncher moved to fastmem
	- keyboard acknowledge fixed
	- two possible access faults fixed (reported by Angus but not
	  reproduceable)
	- the third version of the game is no longer supported because
	  if have no images for it and can therefore not adapt the patches,
	  you will get 'unsupported version' requester for it, send me
	  images and I will add support

	version 1.7 (04.04.2007) by Wepl:
	- savegames fixed, no longer requires disk in drive on some setups,
	  because savegames are dependent on the used expmem, an check has
	  been added to allow loading a game only if the memory configuration
	  matches (previous savegames made with fastmem configurations cannot
	  be loaded anymore), if it doesnt match it will tell 'Saved game has
	  wrong memory address'
	- fastmem support is disabled by default, it can be enabled with
	  Custom1=1 with the effect that savegames can only loaded when
	  WHDLoad uses the same memory location for expmem
	- another version supported
	- some possible access faults fixed
	thanks to Angus Manvaring, Seppo Typpö and Joseph Bailey for testing

Icons contained in install package

WHDLoad Slave information
Cybercon3.Slave - 04.04.2007 21:21:24 - 1372 bytes
required WHDLoad version10
flagsDisk NoError
required Chip Memory512 KiB ($80000)
required Expansion Memory64 KiB ($10000)
info nameCybercon 3
info copy1991 U.S.Gold
info installfixed and installed by Graham/Wepl
on (04.04.2007) V1.6

Install Archive Content Listing
UnpackedLvlMethodPackedOSDate/TimeName
163820lh5135302007-01-16 12:47:20Cybercon3 Install\Cybercon3.colexot
76220lh566442007-01-16 12:47:46Cybercon3 Install\Cybercon3.colicon
59120lh57981998-07-24 13:28:36Cybercon3 Install\Cybercon3.inf
112080lh588752007-01-16 12:47:14Cybercon3 Install\Cybercon3.newexot
13720lh510832007-04-04 21:21:24Cybercon3 Install\Cybercon3.Slave
15840lh510512007-01-16 12:44:00Cybercon3 Install.info
296290lh576122007-01-16 14:23:24Cybercon3 Install\Install
12540lh58312007-01-16 12:44:50Cybercon3 Install\Install.info
483350lh5198082003-11-25 09:01:46Cybercon3 Install\Manual
19900lh513082006-12-21 09:57:42Cybercon3 Install\Manual.info
36420lh518502007-04-05 16:09:26Cybercon3 Install\ReadMe
19900lh513102000-09-11 00:37:22Cybercon3 Install\ReadMe.info
107920lh544942001-01-09 03:55:00Cybercon3 Install\Solution
19900lh513142006-12-21 09:57:42Cybercon3 Install\Solution.info
94370lh537362007-04-04 21:26:18Cybercon3 Install\src\Cybercon3.slave.asm

Old Install Archives
Cybercon3-19990111.lha
Cybercon3-20070118.lha
Cybercon3-20070316.lha

[Main] [Docs] [Installs] [Search] [Team] [Guestbook] [Links]

last change : 2024-03-14
© 1996-2024 Bert Jahn, All Rights Reserved