THIS PACKAGE COMES WITH ABSOLUTELY NO WARRANTY OF ANY KIND, EITHER EXPRESS OR
 IMPLIED, STATUTORY OR OTHERWISE. THE ENTIRE RISK AS TO USE, RESULTS AND
 PERFORMANCE OF THE PACKAGE IS ASSUMED BY YOU AND IF THE PACKAGE SHOULD PROVE
 TO BE DEFECTIVE, YOU ASSUME THE ENTIRE COST OF ALL NECESSARY SERVICING,
 REPAIR OR OTHER REMEDIATION.
 UNDER NO CIRCUMSTANCES, CAN THE AUTHOR BE HELD RESPONSIBLE FOR ANY DAMAGE
 CAUSED IN ANY USUAL, SPECIAL, OR ACCIDENTAL WAY, ALSO IF THE OWNER OR A THIRD
 PARTY HAS BEEN POINTED AT SUCH POSSIBILITIES OF DAMAGE.

 This install applies to the "Action Replay MKII/III Loader" © 1991 Datel
 Electronics.

 Requirements:
 -------------
 This install requires WHDLoad version 17.0 to be in the path.
 It can be found in the WHDLoad package.

 The installed program requires 1 MB ChipMem and 0.5 MB OtherMem.
 It can be quit by pressing F10 (key can be changed with Tooltype "QuitKey=").

 Features:
 ---------
 This Slave is able to load freezed states created by the Monitor Action
 Replay. These files are normally loaded via the Aload program provided by the
 Monitor. It supports freezed files from the MKII and MKIII revisions of the
 Monitor. Due Memory limitations only freezed files containing 512K or 1M chip
 memory are supported. Files containing slow memory ($C00000) or fast memory
 ($200000) cannot be loaded, an error message will be displayed is such cases.

 Please note that despite the freezed program can be restored, it does not
 mean that it will be properly working on a different hardware (cpu, chipset,
 ...). Note also that it will fail if it tries to access the kickstart rom
 (except the kickstart rom is the same as when freezed and no mmu is used).

 The Slave uses 1MB chip memory. For freezed files which need only 512KB it
 would be possible the assemble a Slave which requires only 512KB. The
 source for the Slave is included.

 The name of the freezed file to load must be specified using the Custom
 option. Use either tooltype Custom=Filename or the same on the command
 line.

 If the option Custom1=1 is set, the Slave will also restore the floppy drive
 status. Normally that should not be neccessary, except you want the program
 to load addtional data from floppy disk.

 History:
 --------
 version 1.0 (23.12.2015) done by Wepl:
 - initial release


 Contact:
 --------
 If you have problems with this installation please try and get a newer
 version of this package from the WHDLoad WWW-Page. If that doesn't help try
 some Tooltypes like NOCACHE, NOAUTOVEC, EXPCHIP, NOMMU, PAL or NTSC. If
 that also fails, please inform the author via the Bug-Report-Form which
 can be accessed on the WHDLoad WWW-Page.

 For the full WHDLoad package, other installs and updates refer to:
	http://www.whdload.de/
 or	aminet:dev/misc/whdload#?
 and	aminet:game/patch/